The T-65B X-wing starfighter was a single-seat craft manufactured by Incom Corporation and used most famously by the Alliance to Restore the Republic during the Galactic Civil War. Renowned for its speed and maneuverability in battle, it became the backbone of the Rebel Alliance Starfighter Corps being both harder hitting and tougher under fire than its main adversary—the mass produced TIE/ln space superiority starfighter.
T-65B X-wing starfighters were manufactured by Incom Corporation. They had two pairs of wing-like strike foils, or S-foils, mounted at the rear of the craft on opposite sides. Normally, the foils on each side locked in place flush against each other; during combat, however, the foils were folded out. This gave the craft its distinctive "X"-like appearance when viewed from the front or rear. The S-foils were controlled by an S-foil servo actuator located in the back of the starfighter. With the S-foils open in attack position, the craft had a greater spread of fire as opposed to whilst shut.
The craft was armed with four Taim & Bak KX9 laser cannons ( ), placed at the tip of each wing. Two Krupx MG7 proton torpedo launchers were located in grooves near the middle of the underside of the fuselage on either side of the T-65B. Four 4L4 fusial thrust engines were attached to the wings of the T-65B, next to the fuselage. The X-wing itself was powered by a Novaldex 04-Z cryogenic power generator located in the center of the ship.
The single pilot sat in the cockpit, in the center of the fuselage, protected by a transparisteel canopy. The astromech droid had a socket near the engines and assisted with both repairs and calculations. In the cockpit, the pilot had access to the flight controls and a targeting computer. The T-65's sensor systems were located inside the X-wing's nose cone. The sensor system, a Carbanti transceiver package, was made up of a Fabritech ANs-5d "lock track" full-spectrum transceiver, a Melihat "Multi Imager" dedicated energy receptor, and a Tana Ire Electro-photo receptor.
These highly maneuverable fighters measured 12.5 meters in length, with a mass of 10 metric tons Under the X-wing was a cargo compartment. They were equipped with a long-range hyperdrive system and shields which could be adjusted around the craft with the help of a Chepat "Defender" deflector shield projector and a deflector shield generator. Painted stripes on the rear of the S-foils identified each craft.
The T-65B X-wing starfighter was envisioned by its designers as a fighter with both the speed and power to take on Imperial Star Destroyers, ultimately delivering on both promises. It managed not only to become the backbone of the Rebel Alliance Starfighter Corps, but incorporated lessons learned in assessing the performance of Clone Wars–era winged starfighters, such as the popular Z-95 Headhunter and the powerful ARC-170 starfighter.
The Rebel Alliance used the X-wing extensively during the Galactic Civil War against the Galactic Empire. While X-wing starfighters were initially in general use, they eventually became solely affiliated with the Rebellion. Constantly hiding from Imperial detection, the Rebellion cleverly resorted to building its T-65B's in hidden drydocks and hangars, far from the prying eyes of Imperial spies.
A squadron was kept at their hidden fortress on Yavin 4. During the Battle of Yavin, Luke Skywalker was assigned to an X-wing for the battle, the goal of which was to destroy the Empire's approaching Death Star. Although many of the X-wing pilots were killed, Skywalker was able to launch his proton torpedoes into the battlestation's exhaust port, causing a chain reaction and destroying it. Wedge Antilles was the only other X-wing pilot who survived.
Aside from the Rebel Alliance, the Partisans, a loosely-affiliated group led by Saw Gerrera, utilized the X-wings as well, although they were given extensive paint jobs matching their organization, with several of them being used by the Cavern Angels, as well as Edrio.
Shortly after the Battle of Yavin, the mercenary Saponza and his partner were involved in training X-wing pilots. They used a specially-modified astromech droid in order to draw out womp rats, and a team of 20 X-wings were deployed to test their skills.
The Rebels also brought X-wings to their new headquarters, Echo Base on Hoth. They were launched during the Empire's invasion of the base to protect the escaping transports. Then-rookie pilot Adon Fox was the sole X-wing pilot assigned to protect his wife's transport, but it did not make it past the Imperial blockade. After escaping, Skywalker avoided the rendezvous point to visit with Jedi Master Yoda on Dagobah. He then took his X-wing to Cloud City on Bespin to rescue his comrades.
For the climactic Battle of Endor, the Rebel Alliance assembled their entire fleet for the assault on the Death Star II. X-wings were assigned to Red Squadron for the battle under the command of Wedge Antilles. Although several X-wings were destroyed, Antilles used his fighter to destroy the battlestation's power regulator, contributing to its destruction.
X-wing fighters were also present at the Battle of Jakku, and at least one fighter was shot down during the battle and its wreckage was preserved at the desert surface for nearly thirty years.
In the years following the destruction of the Galactic Empire, newer X-wing models such as the T-70 X-wing starfighter would eventually fall into the hands of the Resistance, and the T-85 X-wing would see use in the New Republic Defense Fleet.
At some point after Snoke drew Ben Solo to the dark side of the Force, renaming him Kylo Ren, he and the Knights of Ren killed all of Skywalker's students and burned the Jedi Temple. Skywalker went into exile, and went in search of the First Jedi Temple. Before leaving, he gave half the map to his astromech droid, R2-D2, and the other half to Lor San Tekka. After traveling to Ahch-To, he purposely crash-landed his X-wing in a shallow inlet, leaving himself stranded on the island, and cut himself from the Force. Skywalker later salvaged an S-foil from the X-wing which he used as a door for his hut.
Behind the scenes
The X-wing appears in the original trilogy. The sound for it was generated by a passing artillery shell. The concept art designed by Ralph McQuarrie for the X-Wing shows the two engines split into four smaller engines on each wing when S-foils are open. This design was later used for the Z-95 Headhunter.
Originally, Red Squadron was going to be named Blue Squadron. However, the limits of blue-screen technology in the late 1970s caused problems for the blue markings, so the squadron name and color was changed. The original designation was retained for the A New Hope novelization. The first X-wing model was built in 1975 by Lorne Peterson, Grant McCune, and Steve Gawley as Blue One before the squadron name was changed. This model was later repainted as Red Two.
Several models, including both "hero" and "pyro" models (simpler casts taken from the "hero" X-wings and rigged to be blown up for effects shots) were built by ILM for the original film. Between the two types, at least eight of Red Squadron's X-wings were represented: Red One, Two, Three, Four, Five, Six, and Twelve have all been confirmed, with the eighth unidentified. Red Four and Six were pyro models destroyed during filming, while only the wings of Red Five have survived. The only model known to remain intact today is the hero model for Red Three, and the fates of the others are unknown.
Despite the number of models built, they were ultimately used in effects shots with little regards to continuity (such as Red One appearing in the trench with Red Five). When the effects teams on the Special Editions later created new footage for the Battle of Yavin using CGI, only two different sets of markings were recreated—those of Red Two and Five—and applied to all X-wings in the revised battle scenes.
For the Star Wars Anthology Series film Rogue One , the X-wings at the Rebel base were realized by a combination of full-size props and cutouts, similar to the fighters in the original Star Wars film.
A new version of the X-wing, known as the T-70 X-wing starfighter, appears in Star Wars: Episode VII The Force Awakens. With its wings closed, the craft looks much closer to Ralph McQuarrie's original concept sketches than the effects models from the final films. However, the wings on this version scissor open along the span rather than split across the chord as in the original design, resulting in distinct forward and aft wings, with the forward lower wings being somewhat narrower in chord than the aft upper wings.
- "Rogue One: Recon A Star Wars 360 Experience"
- LEGO Star Wars: The Freemaker Adventures
- Star Wars Epic Yarns: A New Hope
Notes and references
- ↑ 1.0 1.1 1.2 1.3 Ultimate Star Wars
- ↑ 2.0 2.1 2.2 2.3
- ↑ 3.00 3.01 3.02 3.03 3.04 3.05 3.06 3.07 3.08 3.09 3.10 3.11 Star Wars: Episode IV A New Hope
- ↑ 4.0 4.1 The Empire Strikes Back: So You Want to Be a Jedi?
- ↑ Star Wars Super Graphic: A Visual Guide to a Galaxy Far, Far Away
- ↑ 6.0 6.1 6.2 Star Wars: Ships of the Galaxy
- ↑ 7.00 7.01 7.02 7.03 7.04 7.05 7.06 7.07 7.08 7.09 7.10 7.11 7.12 7.13 7.14 7.15 7.16 7.17 7.18 Star Wars: Card Trader
- ↑ Star Wars Encyclopedia of Starfighters and Other Vehicles
- ↑ 9.0 9.1 9.2 9.3 9.4 Star Wars: Episode V The Empire Strikes Back
- ↑ 10.0 10.1 10.2 Star Wars Battlefront: Battle of Jakku DLC
- ↑ Bloodline
- ↑ 13.0 13.1
- ↑ 15.0 15.1 Star Wars: The Force Awakens: Incredible Cross-Sections
- ↑ 16.0 16.1 Before the Awakening
- ↑ Lost Stars
- ↑ Star Wars: X-Wing Miniatures Game – Saw's Renegades Expansion Pack
- ↑ Star Wars: Commander
- ↑ "Blade Squadron"—Star Wars Insider 149–150
- ↑ Star Wars: Episode VI Return of the Jedi
- ↑ 22.0 22.1 Star Wars: Episode VII The Force Awakens
- ↑ 23.0 23.1 23.2 Star Wars: Episode VIII The Last Jedi
- ↑ Star Wars: Absolutely Everything You Need to Know, Updated and Expanded
- ↑ Star Wars: The Last Jedi: The Visual Dictionary
- ↑ http://www.makmodeler.com/?p=951